SafetyMaster RCA0055 Servo-Strommesser bis 10A

Envelop Weet direct wat je verbruikers aan stroom afnemenop de ontvanger. Met alarm instelbaar.

€ 24.90 *Prijzen zijn inclusief btw

Fabrikant: ESKY
Artikelcode: RCA0055

0 ster(ren) met 0 review(s) Schrijf een review

Op voorraad

Aantal

Using the SafetyMaster

Prepare your model for flight with all servos connected and plug the SafetyMaster between

power source and receiver. Once connected the SafetyMaster will show the main screen

listing voltage, current and so on. In order to navigate through the different SafetyMaster

screens press the "Next" button.

"Inc +" and "Dec -" buttons are for setting the thresholds in the warning screens.

By pressing "Next" you get: Main screen > Graph screen > Warning settings and back.

Screen navigation is looped so you just have to press "Next" until you get to the desired

screen. Before starting to check your R/C system it is necessary to correctly set all the

warnings - in order to use your SafetyMaster to it's full potential.

Measuring:

Turn on your transmitter.

Plug the SafetyMaster output into the receiver and to your Rx battery or ESC.

Check the screen of the SafetyMaster to make sure everything is OK.

Move all the controls of your model together in order to get the maximum load.

NOTE: if you're using an electric motor remove the propeller or disconnect the motor

in order to avoid accidents.

Carefully check the screen of the SafetyMaster for problems.

Main Screen

The main screen gives all the necessary information about what's going on inside your

model: battery voltage, current draw, wattage, max current draw recorded and minimum

voltage detected. If the maximum current or the minimum voltage threshold is exceeded, a

warning message appears on the screen, indicating which value is exceeded.

Merken	ESKY

	Aantal	Artikel	Startprijs	Daarna	Periode	Totaal
	Aantal	Artikel	Stukprijs	Totaal
		Aantal:	(Cadeau)